A device for converting electrical energy directly into mechanical energy. Traditional forms of electric motor are ****d on the force experienced by a current-carrying wire in a magnetic field. Motors can be, and sometimes are, run in reverse as a generator.
Simple direct-current motors consist of a magnet or electromagnet (the stator), and a coil (the rotor) which turns when a current is passed through it because of the force between the current and the stator field. So that the force keeps the same sense as the rotor turns, the current to the rotor is supplied via a commutator – a slip-ring broken into two semicircular parts, to each of which one end of the coil is connected, so that the current direction is reversed twice each revolution.
Cutaway of a fractional-horsepower single-phase induction motor, as used in many light-industrial applications. This motor has a squirrel-cage rotor which is not wired into the electrical circuit. Since a single-phase motor with a squirrel-cage rotor can start from standstill, a secondary circuit is included in which a capacitor is causes the current in a starting winding to lead the applied vol***e, thus enabling rotation to begin. When the rotor reaches a certain speed, a centrifugal switch opens and the capacitor circuit is cut out, leaving the motor to run using only its main winding.
For use with alternating-current supplies, small DC motors are often still suitable, but induction motors are preferred for heavier duty. In the simplest of these, there is no electrical contact with the rotor, which consists of a cylindrical array of copper bars welded to end rings. The stator field, generated by more than one set of coils, is made to rotate at the supply frequency, inducing (see electromagnetic induction) currents in the rotor when (under load) it rotates more slowly, these in turn producing a force accelerating the rotor. Greater control of the motor speed and torque can be obtained in "wound rotor" types in which the currents induced in coils wound on the rotor are controlled by external resistances connected via slip-ring contacts.